Download your Gardening Guides & Protect your Garden Sprinkler with our 365 Days Extended Warranty
Your experience with the products is our guideline. If any concerns, send us an e-mail at support@carpathen.com and we will get to you in 24 HOURS. We couldn't sell the sprinkler without backing it up with our personal assurance of Customer Satisfaction and Enjoyment!
HOW TO USE
PREPARING THE SPRINKLER
Attach the sprinkler head to the base and turn it clockwise to gently tighten it. freely. Excessive tightening may restrain the rotation. If this happens, loosen the head a little bit.
.
The Mesh Filter Washer is mean to collect any debris or sediments from the water, thus preventing them from clogging the nozzles or the rotating head. Make sure to place it in the sprinkler inlet, before attaching the hose. You will need to clean it every now end then, especially if you observe a reduction in water flow.
CONNECTING THE SPRINKLER TO THE HOSE
a. Attach the garden hose directly to the sprinkler's water inlet and turn it clockwise to tighten it.
.
b. Attach the Threaded Hose Quick Connect Adaptor (E) to your hose and the Male-Male Quick Connect Adaptor (B) to sprinkler's water inlet to create a Quick Connect system that will let you connect and release your hose to the sprinkler fast and easy.
SETTING THE SPRINKLING PATTERN
Each of the 3 arms of the Carpathen Garden Sprinkler can rotate to set the sprinkling nozzles number to 3, 4, or 5. More nozzles cover an area closer to the base with a lesser distance reached. Fewer nozzles increase the distance reached but will also leave a small area uncovered near the base.
.
Tip: the 3-3-5 combination will give you an increased distance reached while still fully covering the area around the base.
LINKING MULTIPLE SPRINKLERS
To link another Carpathen Garden Sprinkler in the series, remove the Cap (H) from the outlet of your first sprinkler. You can either directly attach your hose to the sprinkler's outlet, or use the Female-Male Quick Connect Adaptor (C) to adapt the outlet to a Quick Connect System (see 2.1 and 2.2).
.
Observations:
Naturally, each additional sprinkler added decreases water pressure and also the distance covered. The maximum number of sprinklers that can be connected depends on your maximum water pressure.
.
The recommended water pressure for optimum functionality of one sprinkler is 45-50 PSI. However, it can go as low as 30 PSI and up to a maximum of 60 PSI. When linking 2 sprinklers in a series, for optimum results, we recommend having a minimum of 60 PSI water pressure.
FAQ
In case there is water leaking at any threaded joints, first, make sure that the rubber washer ring is in its place and good condition, then try to tighten a little more the connection. If the problem persists, wrap a few layers of Thread Seal Tape (I) in the clockwise direction over the male thread, before connecting the parts.
If for any reason the sprinkler is not stable enough on the ground and tends to roll, use the Hose Anchors (J), next to the sprinkler, to fix the hose on the ground.
